Yaesu FT-51R Owner's Manual page 54

Selecting Message Operation
When sending messages, you can also have
your ID included; "ti!EW'or else ' ' t ZBi3 /D"ap-
pears at the left of the display indicating if one
or both are to be sent (and displayed). Likewise,
while receiving, this selection determines if the
ID will be correctly formatted and displayed
when a message is received. Message operation
can also be disabled completely, if desired.
To choose the message mode you will use;
Press (OM)+&,
then repeatedly press
for the desired mode; message, message
or disabled(no icon displayed).
Storing Personal ID and Messages
Before sending and receiving messages, you
will want to store your personal ID in the special
slot reserved for this purpose. Your ID could be
your callsign, name or any other identifying
characters. To do this:
and
hold the
Press
second; one of the factory message shown
at the left (or another previously stored mes-
sage) will appear in the lower display.
If not already displayed, press
appears in place of the main channel fre-
ID
(outgoing)
button for longer than
A
until
I.D. Memory
DUP
I.D. Code (name, abbreviation)
up to 8 characters in length.
quency display. If the ID slot has not been
previously overwritten, the factory pro-
grammed ID should appear in the
lower display as shown above.
Hold (OM> for second so the first character
of the ID name blinks.
Rotate the to select the first character of
DIAL
the message and press
and move to the next place.
Repeat the above step to complete the mes-
sage. If you make a mistake entering a charac-
ter, press to backstep to the incorrect
(BAND)
character, enter the correction and continue.
When the desired message is displayed, press
to save the entry and exit.
Slot
S
RPT SET!)
to save the entry
(REV)