Yaesu FT-51R Owner's Manual page 50

If you press your
PTT
page, the transceiver sends the other station's ID
code, a DTMF "star" (*) followed by your own
3-digit personal ID code (Code Memory f J ) all
automatically, and then resets the radio to re-
ceive another call.
Unless you are using the Trigger Paging func-
tion (covered next), you may want to switch
from paging to code squelch mode once contact
is established. Just press
appears. Either you or the other station
"CODE
will also have to select Code Memory
you will both be using the same DTMF code
(either, but not both, must re-select their Code
Memory).
With the Code Squelch activated in this man-
ner, you will hear three DTMF code digits trans-
mitted when you press your
are the digits stored in the Code Memory cur-
rently selected (and displayed in place of the
100's-of-MHz digit if the One Touch Paging op-
tion is enabled), and they will open the squelch
of the other station.
Therefore, at the start of each transmission,
you must wait a second or two after pressing the
switch after receiving a
once, so that
so that
switch. These
Paging Tx Delay
When calling other stations using DTMF
Paging or Code Squelch, particularly
through repeaters, you may find that some
stations are unable to receive your calls. This
can be caused by their receiver squelch not
opening fast enough (after receiving your
transmitted carrier) to allow all of the DTMF
digits to be received and decoded.
To correct this problem, you can set a longer
delay (750 ms) between the time your trans-
mitter is keyed and the time the first DTMF
digit is sent.
Press then rotate the
select
toggle from the default delay (
long delay ms).
(
switch for the DTMF code to be sent (you
will hear it in your speaker).
When you finish your conversation, if you
need to reactivate DTMF Code Paging, press
until is again displayed.
PAGE
to
DIAL
Press or to
ms) to