Yaesu FT-51R Owner's Manual page 32

To store a frequency in memory:
Select the desired frequency (and repeater
split manually, if desired) in the VFO mode as
already described.
Hold (SM) %-second (until a second beep
sounds). The icon appears blinking.
Within five seconds of pressing (OM), turn the
or press or
DIAL
memory for storage. If you select one that is
already being used (stored with data), it will
be overwritten with new data in the next step.
Press m a g a i n momentarily to store the dis-
played data into the selected memory. The
memory label stops blinking for a second,
then disappears as operation continues in the
VFO mode. If you timed out, nothing new was
stored into the memory (simply start again).
Example: Store the 447.50/442.50 repeater data
in memory 5.
First set up the desired frequency and offset
on the VFO (see page 18).
for V2-second (
Hold
memory channel number is displayed, then
do the next step within 5 seconds.
to select the desired
blinks) so the
Turn the or p r e s s 0
DIAL
so that
(the memory number to store)
blinks in the lower display.
Press (OM> again, momentarily. That's it. The
VFO data has been stored in memory 5, and
you are left operating on the VFO.
Turn the to change the VFO frequency,
DIAL
then press to change from the VFO to the
memory mode. You should see
the display bottom, and
quency) should appear on the top right of the
display. You can press
mit frequency of 442.50 MHz. Any memory can
be used with the same result except
which requires a sliGht17 different procedure.
Notice that pressing
last stored or used
always recalls the
if necessary,
appear in
(the receive fre-
to confirm the trans-
(REV)
from the VFO mode
memory.