Transceiver Cloning - Yaesu FT-8500/mh-39 Manual

Transceiver Cloning
You can transfer all data stored in one FT-8500 to
another set automatically by a cloning procedure.
This requires a user-constructed cable to connect
the DATA jacks on the two transceivers as shown
below.
:J
Insert the clone cable into the
DATA
jack of each
transceiver.
n
Turn both units off, then press and hold the
;,Q)~
key
of each radio while turning the power on again.
(LOt
~E
t 10DE
appears on the display.
DATA
JACK
o
On the destination transceiver, press @rJ
-tcID,
the
display shows
<
~·JA
I TI
t'~G
DATA:>.
Next press
@rJ
-t@)
on the source transceiver so the display
shows
<
SEt'~D
I
t'~G
DATA:>.
After successful data
transfer,
<
CLOt'~E
DRTR:>
appears again on both
transceiver displays. If there was a problem,
<: EPPOP
>
appears on the display, recheck your
cable and then turn both transceivers off and try
again.
CJ
Remove the cloning cable. Channel and operating
data for both transceivers are now identical.
53