Menu Selection And Settings - Yaesu FT-1000MP Operating Manual

Menu Programming - Selection & Settings
(SE BREST Es SMH a SAS TS TR TD AN OE
Menu Selection and Settings
Introduction
In the last chapter, basic and advanced opera-
tion were covered to explain the various trans-
ceiver features. This chapter covers all of the
menu selections entries and their settings used by
the transceiver. These functions were described
previously, but must be configured as desired
using menu programming. Menu selections are
shown as they appear in the display to assist you
as you go along.
Menu Selections
Eighty-two transceiver settings are contained
in programming menu (refer to the menu list
shown on the opposite page). To view and edit
menu selections, press FAST J:
FAST
is Cj) FE]
The SUB VFO-B display shows the selection
name, while MAIN VFO-A display shows the cur-
rent (default) setting.
Rotating the MEM/VFO CH knob displays the
various selections, whose numbers appear in the
memory channel box.
Rotating the Main VFO knob lets you choose
between the various settings available for the dis-
played selection. Some settings are merely an
off/on switch, while others are variable tuning step
sizes, time and frequency values, or mode
choices.
use the MAIN VFO knob
to change default settings
Selection Number
Selects the number of default memory chan-
nels (from 1-99) made available from within group
1. If all 99 memory channels are enabled, group 2
is not configurable.
Selects the number of default memory chan-
nels (from 1-99) made available from within group
2 if less than 99 memory channels are enabled in
group 1. If all 99 memory channels are enabled,
group 3 is not configurable.
Selects the number of default memory chan-
nels made available from within group 3 if groups
1 and 2 are not configured for 99 channels total. If
all 99 memory channels are enabled, group 4 is
not configurable.
Selects the number of default memory chan-
nels made available from within group 4 if groups
1, 2, & 3 are not configured for 99 channels total.
If all 99 memory channels are enabled, group 5 is
not configurable.
Selects the number of default memory chan-
nels made available from within group 5 (to 99
total) if groups 1, 2, 3 & 4 are not configured for 99
channels total.
ae ed
LSB
Selection Name
|
|
MEM/VFO CH
DOWN ~——~__ up
V4 \\ use the MEM/VFO CH
knob to choose the
menu selection
name & number
page 85