Easy Access Transmitter - Automatic Technology GDO-4 EasyRoller Installation Instructions Manual

THE EASY ACCESS TRANSMITTER
(Not available on some models)
The Easy Access Transmitter is prepared ready for use with the
battery pre-installed. Before the transmitter can be operational,
the Transmitter Code has to be stored into the openers memory.
To store the code please follow the instructions in Step 8.1 on
page 14.
REMOVING THE COVER TO REPLACE BATTERY
1. Rotate the cover Clockwise to 'OPEN'
2. Rotate the cover Anti-clockwise to 'CLOSE'
REMOVING THE BATTERY
(Battery Type: 3V Lithium Battery CR1220).
Use a non-metallic object (e.g Pen) to remove the battery.
(see Fig. 8)
WARNING
Metallic objects used to remove the battery may DAMAGE the
the circuit board or the battery.
REPLACING THE BATTERY
Place one side of the battery into the battery holder (Fig. 9),
then press the battery down firmly until it clicks into a flat
position.
Note: The length of the manual release cord is user adjustable
simply by sliding the plastic toggle along the cord to achieve
the desired length.

EASY ACCESS TRANSMITTER

PRESS BUTTON
8
ROTATE
FIG. 6
FIG. 7
FIG. 8
FIG. 9