Replacing A Linked Scanner; Communication Between The Cordless System And The Host - Honeywell Voyager 1450g Series User Manual

Scan the linking bar code on the top of the Access Point to establish a connection
between the Access Point and the scanner. The scanner emits a short beep and
flashes the green LED to confirm a connection with the Access Point. The Access
Point's Page button remains blue.

Replacing a Linked Scanner

If you need to replace a broken or lost scanner that is linked to a base or an Access Point, scan the Override Locked Scanner
bar code below with a new scanner and place that scanner in the base, or scan the Access Point linking bar code. The locked
link will be overridden; the broken or lost scanner's link with the base or Access Point will be removed, and the new scanner will
be linked.
Communication Between the Cordless System
and the Host
The cordless scanner provides immediate feedback in the form of a "good read" indication with a green LED on the scanner and
an audible beep. This indicates that the bar code has been scanned correctly and the base or Access Point has acknowledged
receiving the data. This is possible since the cordless system provides two-way communication between the scanner and the
base or Access Point.
When data is scanned, the data is sent to the host system via the base or Access Point. The cordless scanner recognizes data
acknowledgement (ACK) from the base or Access Point. If it cannot be determined that the data has been properly sent to the
base or Access Point, the scanner issues an error indication. You must then check to see if the scanned data was received by
the host system.
1. Scanner reads code and gets ACK from base or Access Point
2. Base or Access Point sends data to host
3 - 2
Override Locked Scanner
(Single Scanner)
1
2
2