Table of Contents
Advertisement
SAFETY Continued
10. Do not operate burner system if any log is broken.
11. Do not operate burner system with glass door removed, cracked
or broken.
12. Do not obstruct the flow of combustion and ventilation air in any
way. Provide adequate clearances around air openings into the
combustion chamber along with adequate accessibility clearance
for servicing and proper operation.
13. Do not install stove with burner system directly on carpeting, vinyl
tile, or any combustible material other than wood. The stove must
set on a metal or wood panel extending the full width and depth
of the stove.
14. This stove must be properly connected to a vent system. This
stove is equipped with a vent safety shutoff system.
Cast Iron
Stove Body
Log
Set
Piezo
Ignitor
Figure 1 - IHP B-Vent Burner System Shown Installed in Approved IHP Cast Iron Stove Body
4
PRODUCT IDENTIFICATION
Blower with
Adjustment
Knob (Optional
Installation)
LO
IN
OUT
Control
Valve
www.Superiorfireplaces.US.com
LOCAL CODES
Install and use stove and burner system with care. Follow all local
codes. In the absence to local codes, use the current National Fuel
Gas Code ANSI Z223.1/NFPA 54*
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
PRODUCT FEATURES
OPERATION
This B-vent cast iron stove with burner system is clean burning and
vents vertically. Heat is generated by both realistic flames and glowing
embers. When used without the blower accessory, the stove with
burner system requires no electricity making it ideal for emergency
backup heat.
PIEZO IGNITOR
This burner system has a piezo ignitor. This system requires no
matches, batteries, or other sources to light burner system.
Vent Opening
Rear
Cover
Pilot
Assembly
Grate
Assembly
Cast Iron Stove Body
Stove
Front
Burner
Lava
Rock
Glowing
Embers
127116-01A
Advertisement
Table of Contents
