Table of Contents
Advertisement
INSTALLATION Continued
6. Lava rock may be placed along sides and front inside burner
system bottom. This may not be visible when you have replaced
the front of stove. It is not necessary to use all of the lava rock
provided.
NOTICE: Do not put lava rock on burner or under burner.
Placing lava rock on burner could cause performance
problems.
Ember
Material
Figure 28 - Placing Ember Material on Burner
7. Pull ember material apart into pieces no larger than a dime. Place
these pieces loosely and sparingly directly onto the exposed sec-
tion of front burner and along space between burner and grate
prongs (see Figure 28). This will create the glowing ember ap-
pearance as the flame touches the ember material. Do not block
air slots by using too much ember material in one area. It is not
necessary to use all of the ember material provided.
8. Replace glass door. See Removing/Replacing Glass Door,
page 14.
WARNING: The glass door must be securely in
place before running this burner system. Do not run
this burner system if glass is missing or broken.
16
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
A. This appliance is equipped with an ignition device which auto-
matically lights the pilot. Do not light pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area for gas.
Be sure to smell next to the floor because some gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your
building.
•Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand,
don't try to repair it, call a qualified service technician. Force
or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any
gas control which has been under water.
1. STOP! Read the safety information above.
2. Set ON/OFF switch located on rear cover to OFF.
3. Open lower panel.
4. Turn off all electric power to the burner system.
5. Push in gas control knob slightly and turn clockwise
OFF.
6. Wait five (5) minutes to clear out any gas. Then smell for gas,
including near the floor. If you smell gas, STOP! Follow "B" in the
safety information above. If you don't smell gas, go to the next
step.
7. The pilot is located by the main burner and should not require
accessing for lighting.
8. Turn knob on gas control counterclockwise
9. Push in control knob all the way and hold. Immediately light the
pilot by repeatedly pressing the piezo spark ignitor until a flame
appears. Continue to hold for about one (1) minute after the pilot
is lit. Release knob and it will pop back. Pilot should remain lit. If
it goes out, repeat steps 5 through 8.
• If knob does not pop up when released, stop and immediately
call your service technician or gas supplier.
• If the pilot will not stay lit after several tries, turn the gas control
knob to OFF and call your service technician or gas supplier.
www.Superiorfireplaces.US.com
OPERATION
FOR YOUR SAFETY
READ BEFORE LIGHTING
LIGHTING
INSTRUCTIONS
to
to PILOT.
127116-01A
Advertisement
Table of Contents
