Table of Contents
Advertisement
BURNER SYSTEM ASSEMBLY
INSTALLING B-VENT BURNER SYSTEM INTO STOVE BODY
1. Carefully lift burner system and place into stove body from the
rear of stove.
2. Discard center grate top of stove and replace with center grate top
provided with Cast Iron Stove Body.
INSTALLING REAR COVER
1. Place rear cover behind stove body. Rear cover will rest on the
bottom ledge of the stove body.
2. Using hex screws provided, attach rear cover to back of stove
body. See Figure 22. IMPORTANT: This rear cover must be securely
in place before venting pipes are installed.
3. Open lower door panel. The valve is attached to the underside of
the burner system assembly.
4. Connect or reconnect gas supply, see Connecting Stove/Burner
System to Gas Supply on page 12.
WARNING: A qualified installer or service person
must connect burner system to gas supply. Follow
all local codes.
Center Top Grate
(Included with Cast
Iron Stove Body
Cast Iron
Stove Body
Figure 21 - Installing Burner System Into Cast Iron Stove Body
Hex Screws
Cast Iron
Stove Body
Figure 22 - Attaching Rear Cover and Bottom Cover from Stove Body
14
INSTALLATION Continued
Burner
System
Rear Cover
Mounting
Bottom Cover
Screws
www.Superiorfireplaces.US.com
REMOVING/REPLACING GLASS DOOR
CAUTION: Do not operate this burner system
with a broken glass door panel or without the glass
door panel securely in place. For replacement part
information see Replacement Parts, page 26.
1. Use reverse directions for installing rear cover. Remove stove
insert from cast body.
2. Remove screws from 2 tabs at top of glass door while holding
door securely keeping it from falling forward (see Figure 23).
3. Grasp door by both sides and ease it upward off of lower bracket
(see Figure 23).
4. To replace glass door, follow the above instructions in reverse.
Screw
Glass Door
Figure 23 - Removing Glass Door from Burner System
Cast Iron
Stove Body
127116-01A
Advertisement
Table of Contents
