Table of Contents
Advertisement
10. Turn gas control counterclockwise
11. Turn on all electric power to the burner system.
12. Turn the ON/OFF switch to ON position.
13. Close lower panel.
14. To leave pilot lit and shut off burners only, turn control knob
clockwise
to the PILOT position or set selector switch in
the OFF position.
Piezo
Ignitor
Gas Control Knob
Figure 29 - Control Valve
TO TURN OFF GAS
TO APPLIANCE
1. Set ON/OFF switch located on rear cover to OFF.
2a. Open lower panel.
2b. If Using Optional Hand-Held Remote: Set selector switch in the
OFF position to prevent draining battery.
3. Turn off all electrical power to the appliance if service is to be
performed.
4. Push in gas control knob slightly and turn clockwise
5. Close lower panel.
6. Close equipment shutoff valve (see Figure 17, page 12).
MANUAL LIGHTING
PROCEDURE
1. Remove glass door (see Removing/Replacing Glass Door, page
14).
2. Follow steps 1 through 8 under Lighting Instructions, page 16.
3. Press control knob and light pilot with match.
4. Keep control knob pressed in for 30 seconds after lighting pilot.
After 30 seconds, release control knob. Now follow steps 10
through 13 of Lighting Instructions, page 16.
5. Replace glass door (see Removing/Replacing Glass Door, page
14).
127116-01A
OPERATION Continued
to ON.
Note: All remote control accessories must be purchased separately
(see Accessories, page 26). Follow instructions included with the
remote control.
NOTICE: You must light the pilot before using the
hand-held remote control unit. See Lighting Instruc-
tions, page 16.
After lighting, let pilot flame burn for about one minute. Turn control
knob to ON position. Adjust flame adjustment knob anywhere between
HI and LO. Slide the selector switch to the REMOTE position (see
Figure 30).
Note: The burner may light if hand-held remote was on when selector
switch was last turned off. You can now turn the burner on and off
with the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch in the REMOTE or ON
position when the pilot is not lit. This will drain the battery.
to OFF.
Figure 30 - Setting the Selector Switch, Control Knob, and Flame
www.Superiorfireplaces.US.com
OPTIONAL REMOTE
OPERATION
Selector Switch in Remote
Position (Optional Remote
Control)
Adjustment Knob for Remote Operation
Control Knob
in On Position
17
Advertisement
Table of Contents
