Table of Contents
Advertisement
INSTALLING LOGS, LAVA ROCK, AND GLOWING EMBERS
WARNING: Failure to position the parts in ac-
cordance with these diagrams or failure to use only
parts specifically approved with this burner system
may result in property damage or personal injury.
It is very important to install these logs exactly as instructed in Fig-
ures 24 through 28. Do not modify logs. Only use logs supplied with
freestanding burner system. Do not use if any log(s) are broken (see
Replacement Parts, page 26).
1. Remove glass door. See Removing/Replacing Glass Door, page 14.
2. Place log #1 (back log) on top of grate. Make sure notches in the
bottom of log fit over the grate (see Figure 24).
3. Rest log #2 (large front log) on the pins on the front part of grate
(see Figure 25).
4. Place log #3 (crossover log) onto rear and front logs. Make sure
it is seated properly into notch on front log and over the raised
triangular portion of rear log as shown in Figure 26.
5. Place log #4 (small log) onto front left part of grate making sure
the notches fits over the prong of the grate. See Figure 27.
Figure 24 - Installing Log No. 1
127116-01A
INSTALLATION Continued
www.Superiorfireplaces.US.com
Figure 25 - Installing Log No. 2
Figure 26 - Installing Log No. 3
Figure 27 - Installing Log No. 4
15
Advertisement
Table of Contents
