Connect The Telephone Leads; Configure The Application - Panasonic PanaVOICE system Technician Manual

Technician's Guide
Installing the Pana VOICE system l-9
3.
For the DBS, dial 47#. You see EXT Xxx 647: 0
VAU/VM Port
For the DBS 824, dial 46f#. You see EXT XXX 046: 0
VAU/VM Port.
4.
Dial 1 to enable the voice mail port confirmation.
5. Press
HOLD
to go to the next port number
S. Repeat steps 4 & 5 for each extension.
To set call forward ID codes for individual extensions
I.
At any extension, dial: ON/OFF
PROG AUTO *
2.
Dial the extension number to be forwarded.
3. Dial the voice mailbox ID code. These are the digits required by PanaVOICE to
identify the DBS extension and allow it to retrieve messages. The lD code can be up
to 16 digits long. Press the REDIAL key to insert a pause between digits.
4. Press
HOLD.
5. Repeat for each extension to be programmed with Call Forward ID codes.
Connect the telephone
leads
The telephone leads are plugged into the jacks at the back of the voice boards. For
details, see the Voice Board Note
in Appendix A:
Hardware Documentation.
For Remote IMaintenance. connect an additional extension to PanaVOICE's modem.
Test
the
Pana VOICE
system
Using a telephone near the PanaVOICE console, call each extension connected to
PanaVOICE. Go to the Banner screen (Figure 2) and watch the port status indicator to
verify which voice messaging system port answers your calls.
- -----..
Paw&i~i~
Figure 2 Banner screen