Making Corrections For Printing; Feed Correction - Roland SP-300 User Manual

4-2 Making Corrections for Printing

When you have replaced the media with media of a different type, or when you're using the machine in a location
subject to severe changes in temperature, carry out correction as described below.

Feed Correction

This corrects for errors in the amount of feed of the grit rollers due the type of media. Be sure to make this setting when
you have replaced the media with a different type. Correcting the amount of feed improves the dot-positioning accuracy
in the feed direction, which can help enhance image quality.
When correcting the amount of feed, make the settings for the same conditions for the type of media used, the configuration of
the media (roll media or sheet media), and the heater temperature as when actually performing printing.
When performing test printing for feed correction, load the media correctly (see "2-3 Loading Media"). If the media is not
loaded correctly, the results of the printing test may not show accurate adjustment values.
When you can make a setting for error in the amount of feed for the grit rollers on the computer, the computer's setting takes
priority. To make the machine's setting take priority, turn off the computer's setting.
Setting the Adjustment Value
1 Press the [MENU] key, then press the [ ] key
to select [CALIBRATION].
2 Press the [
ING ADJ.] menu, select [TEST PRINT].
The following screen appears on the display.
Press the [ENTER] key.
3
A test pattern is printed.
4. A wide variety of Operations
60
] key twice, then from the [PRINT-
MENU
CALIBRATION
CALIBRATION
PRINTING ADJ.
PRINTING ADJ.
TEST PRINT
Test Pattern