Control The Projection Monitor With Telnet - Sanyo PJ-Net Organizer POA-PN30 Owner's Manual

Chapter 5 Use of Serial Port

Control the projection monitor with telnet

This product allows you to control the projection monitor by using the telnet appli-
cation. Normally, it is used for controlling the external equipment connected to the
serial port but it also controls the projection monitor by specifying the telnet port
number 10000.
* To control the projection monitor with telnet application is not depending on the serial
port setting.
In the step 2 of the previous page, enter port number "10000" after the IP address number.
> open 192.168.1.201 10000 [return]
After the communication is established, type the password (PIN code) and the com-
mand for controlling the projection monitor and then press "Enter" key.
The table below shows the typical command lists for controlling the our projection
monitor and please consult your local dealer for further information of another com-
mands.
66
* Use the IP address
assigned to the pro-
jection monitor
Command list table
Command Function
C00 Power on
C01 Power off (No LPS)
C02 Power off
C05 Selects input1 (Digital)
C06 Selects input2 (Analog)
C07 Selects input4 (Auto)
C08 Selects input5
C09 Volume up
C0A Volume down
C0B Audio Mute on
C0C Audio Mute off
C0F Screen Normal size
C10 Screen Full size
C1C Menu display on
C1D menu display off
C33 Input4 (Video)
C34 Input4 (S-video)
C35 Input4 (Component)