Notice About System Construction - Sanyo PJ-Net Organizer POA-PN30 Owner's Manual

Notice about system construction

For installation of multiple projection monitors into the same network with Network
Unit.
Do not install multiple projection monitors with Network Units that have their default
network settings to the same network. The use of the Network Units which have the
default IP address set to the same network settings will cause IP addresses to collide
and create a malfunction. When you install multiple projection monitors into the same
network, configure the network with the following steps.
1. Change the IP address from the default IP address. To change the IP address, use
the network setting menu on the projection monitor. Please see item "Network
configuration" for further information (☞ p.18).
2. Make sure that there is no network equipment set with the same IP address in the
network before connecting to the network.
3. When installing other projection monitors, follow the above steps to change the IP
address and connect to the network.
In case of installing the projection monitor with Network Unit into the network con-
structed with the DHCP/BOOTP server.
This Network Unit does not support the DHCP/BOOTP server. The static IP address
must be manually configured. To use this product in this network environment, set it
up so that the DHCP/BOOTP server does not assign the IP address configured to this
product for another device on the network. Please consult your network administrator
for further information.
Installation and network configuration
PJ-NET ORGANIZER
OWNER'S MANUAL
21