Sanyo PJ-Net Organizer POA-PN30 Owner's Manual page 19

2
Configuration for IP Address/ Sub net/ Gateway*
Press MENU button to display the menu. Select network menu and then select
"Network setting" sub menu. To diplay the network setting window, press SELECT
button. Enter the specified network address by using the pointer buttons (▲,
▼,7,8) on the projection monitor or the remote control. Move a red frame cursor
to select the address or number box you intend to change.
Move cursor up
and down with
(▲,▼) buttons
3
Fixing the network configuration
After completing the entering of address, select SET
and press SELECT button. The Network Unit starts
re-booting and displays message "Please wait..." on
the screen until the re-booting is complete. Do not
disconnect the AC cord during this period. After that the
menu will disappear on the screen.
Completing of installation
Now the installation is complete. The IP address of this projection monitor is set to
"192.168.1.201".
Item Description
IP address..........Sets IP address of the projection monitor
Sub net ..............Sets Subnet mask. Normally sets 255.255.255.0
Gateway* ..........Sets IP address of the default gateway (Router)
1
DNS* ................Sets IP address of the DNS server. Must be set when using the e-mail function
2
✻ Refer to the projection monitor's owner's manual for operation of the projection monitor.
*1 In the network environments not using a Gateway or Router, the Default Gateway address
should be set to [0.0.0.0].
*2 If you do not use the functions E-mail or DNS server, it is also set [0.0.0.0] for the DNS
address.
Move cursor left and right
with (7,8) buttons
*The cursor moves to each address item
Change number up
and down with (▲,▼)
buttons
Installation and network configuration
/DNS*
1 2
when pressing the SELECT button if the
cursor is on the number box.
PJ-NET ORGANIZER
OWNER'S MANUAL
19