Table of Contents
Advertisement
Examples: Type and contents of alert mail
When the projection monitor has an abnormality, the following alert messages
are sent to the registered E-mail address according to your selected condition.
Administrator or user can take an efficient action quickly by receiving this message.
This is very useful to maintain and service the projection monitor.
The following are examples of received messages.
● When the internal temperature became too high:
TITLE: Message from PJ monitor
11-03-2004 00:59
PJ monitor Model Name: model name
TCP/IP: 192.168.1.201 PJ monitor Name: Proj_05
It sends you following message.
*The PJ monitor lamp is turned off, because internal PJ monitor temperature is too high.
Wait for Temperature Warning Indicator turned off, and then turn the PJ monitor on again.
If the Indicator continues flashing, check the air filter for dust accumulation.
[A] 81.5.5 degrees fahrenheight [B] 124 degrees fahrenheight
Temperature of Sensor B is too high.
✐ The Network Unit let users know the information which thermal sensor [A] or [B]
inside the projection monitor detected the abnormal temperature risen and so the
projection monitor was turned off. Please refer to item "Power control and status
check" (☞ p.38) for the location of the sensors and each temperature . Also see the
owner's manual of the projection monitor for further details.
● When the internal power circuit failed:
TITLE: Message from PJ monitor
11-03-2004 00:59
PJ monitor Model Name: model name
TCP/IP: 192.168.1.201 PJ monitor Name: Proj_05
It sends you following message.
*The PJ monitor lamp is turned off, because PJ monitor power circuit failed.
Unplug the PJ monitor from AC outlet and ask servicing to qualified service personnel.
✐ The projection monitor lamp was turned off, because the projection monitor power cir-
cuit failed.
Unplug the projection monitor from AC outlet and ask servicing to a qualified service
personnel.
E-mail setting
33
PJ-NET ORGANIZER
OWNER'S MANUAL
Advertisement
Table of Contents
