Connection Of Lan Cable - Sanyo PJ-Net Organizer POA-PN30 Owner's Manual

Connection of LAN cable

To connect to the network, it is required to use the UTP (Unshielded Twisted Pair)
straight cable with RJ-45 plug. There are two different types of cables depending on
whether the network is constructed with 10Base-T or 100Base-TX. Prepare the Hub
(10Base-T or 100Base-TX) to distribute the network cable if required.
1
Disconnect the AC plug from the
projection monitor.
2
Connect the UTP straight cable
to the LAN port on the Network
Unit.
3
Connect the UTP straight cable to the hub.
Hub
(10Base-T, 100Base-TX)
UTP straight cable
✐ Use the UTP cross cable when you connect the computer and projection monitor directly not
using the hub.
✐ When you connect the projection monitor into the 10Base-T network, use cable with category
3 or 5. When you connect the projection monitor into the 100Base-TX network, use cable with
category 5.
✐ The length of cable between hub and projection monitor should be less than 100m.
Installation and network configuration
et
P J- N
er
an iz
O rg
LINK
ACT
Projection monitor
PJ-NET ORGANIZER
OWNER'S MANUAL
17