Table of Contents
Advertisement
Chapter 3 Basic Setting and Operation
Initial Setting
Power & Status
PC Adj.
Control
Setting
E-mail Setting
Save
Network
Multi Control
Timer
Information
SNMP Setting
*1 Set [0.0.0.0] if the network does not provide the gateway (router).
*2 Set [0.0.0.0] if you do not use the function E-Mail alert.
*3 If you use the DNS server, register the host name registered to the DNS server as a projec-
tion monitor name. You can access with this projection monitor name from any computers in
your network. If you do not use the DNS server, access with the assigned IP address to the
projection monitor.
30
Network configuration
Click Network on the main menu. The following setting page
is displayed. This page is to set the IP Address, Subnet
Mask, Default Gateway, DNS (Domain Name Server) and
projection monitor name.
The IP address and Subnet Mask have been configured
already in chapter "Installation". If you want to change them
or configure default gateway or DNS, perform them in
this page. Enter an applicable address number onto each
parameter and click Set button.
The Network Unit begins restarting and it takes about 20
seconds. Close (Quit) the web browser and access to the
login page again in 20 seconds.
Item
Description
IP address .........Sets IP address of the projection monitor
Subnet mask......Sets Subnet mask. Normally sets 255.255.255.0
Default gateway*
...Sets IP address of the default gateway (Router)
1
................Sets IP address of the DNS server. Must be set
DNS*
2
when using the e-mail function
.........Sets name of the projection monitor.
PJ name*
3
✐ You must use the number specified by your administra-
tor. The address must be entered as a group with four
numbers split by a dot like [192.168.001.101].
Advertisement
Table of Contents
