Serial Port Setting - Sanyo PJ-Net Organizer POA-PN30 Owner's Manual

Chapter 5 Use of Serial Port
This product provides a serial control port (RS-232C) to control the external equipment
through the serial cable. This function allows you to control the external equipment
connected to the serial port on the Network Unit through the network, and control the
projection monitor through the serial cable with the external serial controller. Before
connecting the external equipment, perform the setting "Serial Port setting" described
below.
Initial Setting
Power & Status
PC Adj.
Control
Setting
E-mail Setting
Save
Network
Multi Control
Timer
Information
SNMP Setting
Item Description
Baud rate ...........Communication speed for serial port, select with the pull-down menu (300 ~ 115200)
Parity .................Parity check, the ways for error detecting of the transferred data (None, Odd, Even)
Stop bit ..............Stop bit, Select the end of communication (1 or 2)
Flow control .......Ways for communication flow (None, Xon/Xoff, RTS/CTS)
Data length ........Selects the length of data (7 or 8)
Serial control .....Selects equipment to control (External or PJ monitor)
External ........ Used to select when the external equipment connected to the serial
PJ monitor .... Used to select when the projection monitor is controlled by the serial
Port number.......Specifies the port number of TCP/IP . The default number is 23. Use the same port
number specified by application. There are some reserved port numbers*
those port numbers is used, the alert dialog window will appear and let you know that
it is an invalid port number.
*1 This product will restart when "Port number" or "Serial Control" is changed and it takes about
20 seconds.
60

Serial port setting

This is to set up the serial port on the Network Unit.
Display the setting page by clicking Serial Port setting sub
menu in the Initial setting menu. To communicate with
external equipment correctly, communication condition
must be set up to the same values as that the connected
equipment is using. When clicking on any item of the serial
port setting, the setting pallet appears and set up each
item and then click Set button*
port is controlled by the computer through the LAN port.
controller connected to the serial port.
.
1
. If one of
2