Notice About System Construction - Sanyo POA-PN03C Owner's Manual

Chapter 2 Installation

Notice about system construction

For installation of multiple projectors into the same network with network
unit.
Do not install multiple projectors with network units that have their default network set-
tings to the same network. The use of the network units which have the default IP address
set to the same network settings will cause IP addresses to collide and create a malfunc-
tion. When you install multiple projectors into the same network, configure the network
with the following steps.
1. Change the IP address from the default IP address. To change the IP address, use the
network setting menu on the projector. Please see item "Network configuration" for fur-
ther information (+ p.20).
2. Make sure that there is no network equipment set with the same IP address in the net-
work before connecting to the network.
3. When installing other projectors, follow the above steps to change the IP address and
connect to the network.
In case of installing the projector with network unit into the network con-
structed with the DHCP/BOOTP server.
This network unit does not support the DHCP/BOOTP server. The static IP address must be
manually configured. To use this product in this network environment, set it up so that the
DHCP/BOOTP server does not assign the IP address configured to this product for another
device on the network. Please consult your network administrator for further information.