Table of Contents
Advertisement
1101 and 1102 Secure Device Servers
Figure 7-8. Serial port pattern match alert.
UPS Power Status Alert— This alert will be triggered when the UPS power status changes between on line, on battery, and low battery. This
status will only be monitored on the Applicable UPS(es) you select.
Power Alert—(next section).
7.2.3 Configuring Power Alert Type
This alert type monitors UPSes, RPCs, and power devices.
Figure 7-9. Power alert.
Select Power Alert to activate.
Specify which Sensor Type to alert on (Power Load and Battery Charge).
Set the levels at which Critical and/or Warning alerts are to be sent. You can also specify High and/or Low Set Points for sending alerts and the
Hysteresis to be applied before resetting the alerts.
NOTE: Specify the Set Point values in amps (current) for power load and % (percentage) for battery charge.
Specify the applicable UPSes, RPCs (and RPC outlets) to Apply Alert To.
724-746-5500 | blackbox.com
72
Advertisement
Table of Contents
