Table of Contents
Advertisement
NOTE:
Supported serial port baud-rates are '50', '75', '110', '134', '150', '200', '300', '600', '1200', '1800', '2400', '4800', '9600', '19200',
'38400', '57600', '115200', and '230400'.
Supported parity values are 'None', 'Odd', 'Even', 'Mark' and 'Space'.
Supported data-bits values are '8', '7', '6', and '5'.
Supported stop-bits values are '1', '1.5', and '2'.
Supported flow-control values are 'Hardware', 'Software', and 'None'.
Additionally, before any port can function properly, you need to set the port mode. Set any port to run in one of the five possible modes
(refer Chapter 5 for details): [Console server mode|Device mode|SDT mode|Terminal server mode|Serial bridge mode]. All these modes are
mutually exclusive.
Console server mode
The command to set the port in portmanager mode:
# config -s config.ports.port5.mode=portmanager
To set the following optional config elements for this mode:
Data accumulation period
Escape character
log level
Shell power command menu
RFC2217 access
Limit pot to 1 connection
SSH access
TCP access
telnet access
Unauthorized telnet access
# config -s config.ports.port5.delay=100
# config -s config.ports.port5.escapechar=%
# config -s config.ports.port5.loglevel=2
# config -s config.ports.port5.powermenu=on
# config -s config.ports.port5.rfc2217=on
# config -s config.ports.port5.singleconn=on
# config -s config.ports.port5.ssh=on
# config -s config.ports.port5.tcp=on
# config -d config.ports.port5.telnet
# config -d config.ports.port5.unauthtel
Device Mode
For a device mode port, set the port type to ups, rpc, or enviro:
# config -s config.ports.port5.device.type=[ups | rpc | enviro]
For port 5 as a UPS port:
# config -s config.ports.port5.mode=reserved
For port 5 as an RPC port:
# config -s config.ports.port5.mode=powerman
For port 5 as an Environmental port:
# config -s config.ports.port5.mode=reserved
SDT mode
To enable access over SSH to a host connected to serial port 5:
# config -s config.ports.port5.mode=sdt
Chapter 14: Configuration from the Command Line
100 ms
% (default is ~)
2 (default is 0)
Enabled
Enabled
Enabled
Enabled
Enabled
Disabled
Disabled
724-746-5500 | blackbox.com
121
Advertisement
Table of Contents
