Table of Contents
Advertisement
HP ProCurve Switch xl Modules
Replacing or Removing a Module
C a u t i o n
24
Replacing or Removing a Module
Follow these procedures to replace one module with another, or to remove a
module without replacing it:
1.
Remove any network cables from the ports on the module.
(If this is a PoE xl Module, also remove the PoE cable.)
2.
On the module you want to remove from the switch, unscrew the
retaining screws enough to disconnect them from the threaded holes in
the switch.
hp procurve
10
/
100-TX
xl module
J4820A
3.
Grab the screws and pull the module out from the slot. It may help to
brace your hands against the face of the switch and "lever" the module
out from the switch slot.
4.
Do one of the following:
•
If you will be installing another module in the slot, go to "Installing
the Module in an Unused Slot" on
•
If you will not install another module in the slot (that is, leave it
empty), then re-install a slot cover plate over the empty slot opening.
For proper cooling and reduction of electromagnetic emissions, ensure a slot
cover is installed on any unused slot.
5.
Reset the switch, as described under "Resetting the Switch" on
if you are exchanging one type of module with a different type of module
in the same slot (for example, replacing a 10/100-TX xl Module with a
100/1000-T xl Module).
If you are replacing a module with another one of the same type in the
same slot, it is not necessary to reset the switch. The current configuration
for ports in that slot will apply to the new module.
unscrew the retaining screws
page 8
xl
module
and begin with step 2.
page
25,
Advertisement
Table of Contents
