Table of Contents
Advertisement
Module Ready LED—This LED comes on after the module completes the
boot up and self test processes and indicates the module is up and running.
Mode (selected on switch)—These LEDs operate in conjunction with the
Mode Select button on the switch chassis to show port activity, duplex
mode and link speed. For example, if you have selected "Act" with the
Mode Select button on the chassis, then the two Mode LEDs on the module
(Downlink and Uplink) will blink if there is activity on those ports. For
more information refer to LEDs on Page 1-6 of the HP ProCurve Series
5300xl Switches Installation and Getting Started Guide.
Module Activity (10%, 50%, 80%)—These LEDs come on according to the
amount of activity or load the module is experiencing. For example, 10%
indicates that the module has a light load, however, 80% indicates that the
module is nearing work load saturation.
Module Fault—This LED (colored orange) comes on when there is an
error condition detected in the module.
Battery Installation Required
The Access Controller xl Module (J8162A) ships without the clock battery
installed. You must insert the battery before installing the module into the
switch. See the following graphic for instructions.
Insert the battery with the lettering
and the plus "+" sign facing up.
HP ProCurve Switch xl Modules
Battery Slot
Features
Battery
5
Advertisement
Table of Contents
