Table of Contents
Advertisement
Removing or Replacing a Module
Use this section to do either of the following:
Figure 7.
1. Remove any network cables from the ports on the module.
2. Loosen the screws in the extractor handles of the module you want
3. Simultaneously rotate both extractor handles downward and pull the
N o t e
During removal (or installation) the module and switch connectors will
momentarily be only partially connected. The fault LED for the slot
flashes rapidly to indicate this state, and normal switch operation is
temporarily suspended until the module connector is completely
separated from the switch connector. The other switch modules will
continue to forward packets normally, though.
4. Slide the module out of the slot.
Replace one module with another
Remove a module without replacing it
Removing the Module from the Slot
to remove from the switch.
module toward you until it releases from the slot and the Fault and
status LEDs for that slot are off.
loosen these two screws
9
Advertisement
Table of Contents
