•
Diskette drive
•
Tape backup unit
•
Optical drives
6 Remove the two screws that secure the power supply to the system. See
Figure 3-8.
7 Press the power supply release tab, and slide the power supply out from the
back of the system. See Figure 3-8.
8 If you plan to replace a non-redundant power supply with redundant power
supplies, you will need to replace the power supply cage cover with the
power supply distribution board and its shroud.
Remove the power supply cage cover by pulling the blue release pins
a
until they unlock from the power supply cage, and lift the cover out of
the chassis. See Figure 3-41.
Install the power supply distribution board and its shroud. See
b
"Installing the Power Supply Distribution Board" on page 148.
Installing System Components
79