Dell PowerEdge T605 Systems Hardware Owner's Manual page 122

3 Remove the expansion card shroud. See "Removing the Expansion Card
Shroud" on page 72.
4 Locate the USB connector on the system board (see Figure 6-1).
5 Insert the USB memory key into the USB connector on the board. See
Figure 3-30.
6 Install the expansion card shroud. See "Installing the Expansion Card
Shroud" on page 75.
7 Close the system. See "Closing the System" on page 70.
8 Place the system upright and on its feet on a flat, stable surface.
9 Reattach any peripherals, then connect the system to the electrical outlet.
10 Turn on the system and attached peripherals.
11 Enter the System Setup program and verify that the USB key has been
detected by the system. See "Using the System Setup Program" on page 43.
Figure 3-30. Installing an Internal USB Key or NIC TOE key
2
3
1 USB memory key
3 TOE key
122
Installing System Components
1
4
2 internal USB connector
4 internal TOE connector