Figure 3-42. Removing and Installing the SAS/SATA Backplane
1
backplane release pin
3
securing slots (4)
5
backplane connector
7
SAS cable connector
Installing the SAS/SATA Backplane
1 Position the SAS/SATA backplane so that the securing tabs on the chassis
are fully inserted into the securing slots on the backplane. See Figure 3-42.
2 Slide the backplane to the right until the release pin snaps into place.
3
2
1
2
4
6
8
4
5
securing tabs (4)
SAS connector
SAS/SATA backplane
power cable
Installing System Components
6
7
8
151