Chassis Intrusion Switch; Removing The Chassis Intrusion Switch - Dell PowerEdge T605 Systems Hardware Owner's Manual

Chassis Intrusion Switch

Removing the Chassis Intrusion Switch

CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2 Open the system. See "Opening the System" on page 68.
3 Remove the expansion card shroud. See "Removing the Expansion Card
Shroud" on page 72.
4 Disconnect the chassis intrusion switch cable from the INTRUSION
connector on the system board. See Figure 3-37.
5 Slide the chassis intrusion switch out of the securing bracket notch. See
Figure 3-37.
6 Remove the switch and its attached cable from the system.
142
Installing System Components
Many repairs may only be done by a certified service technician. You