Dell PowerEdge T605 Systems Hardware Owner's Manual page 28

Table 1-5. LCD Status Messages (continued)
Code Text
E1A15 SAS Cable D
E1A18 PDB Ctrl
Cable
E1A19 12V Cable
Fault
E1B01 USB#
Overcurrent
E2010 No Memory
E2011 Mem Config
Err
E2012 Unusable
Memory
28
About Your System
Causes
SAS cable D is missing or
bad.
Control cable for the power
distribution board (PDB) is
missing or bad.
Power cable for the PDB or
cabled power supply is
missing or bad. They system
will not turn on.
Device plugged in the
specified USB port caused
an overcurrent condition.
No memory is installed in
the system.
Memory detected, but is not
configurable. Error detected
during memory
configuration.
Memory is configured, but
not usable. Memory
subsystem failure.
Corrective Actions
Reseat the cable. If the
problem persists, replace
cable.
If the problem persists,
see "Getting Help" on
page 205.
Reseat the cable. If the
problem persists, replace
cable.
If the problem persists,
see "Getting Help" on
page 205.
Reseat the cable. If the
problem persists, replace
cable.
If the problem persists,
see "Getting Help" on
page 205.
Reseat the device cable. If
the problem persists,
replace or remove the
device.
Install memory (see
"Installing Memory
Modules" on page 131).
See "Troubleshooting
System Memory" on
page 173.
See "Troubleshooting
System Memory" on
page 173.