Dell PowerEdge T605 Systems Hardware Owner's Manual page 40

Table 1-6. System Messages (continued)
Message
Unsupported CPU
combination
Unsupported CPU
stepping
detected
Utility
partition not
available
Warning: A fatal
error has caused
system reset!
Please check the
system event log!
Warning! No micro
code update
loaded for
processor n
Warning: The
installed memory
configuration is
not optimal. For
more information
on valid memory
configurations,
please see the
system
documentation on
support.dell.com
40
About Your System
Causes
Microprocessor(s) is not
supported by the system.
The <F10> key was pressed
during POST, but no utility
partition exists on the boot
hard drive.
A fatal system error occurred
and caused the system to
restart.
Micro code update failed.
Invalid memory
configuration.
Corrective Actions
Install a supported
microprocessor or
microprocessor combination
(see "Processors" on
page 134).
Create a utility partition on
the boot hard drive (see the
CDs that came with your
system).
Check the SEL for
information that was logged
during the error. See the
applicable troubleshooting
section in "Troubleshooting
Your System" on page 159 for
any faulty components
specified in the SEL.
Update the BIOS firmware
(see "Getting Help" on
page 205).
Ensure that the memory
modules are installed in a
valid configuration (see
"General Memory Module
Installation Guidelines" on
page 128). If the problem
persists, see
"Troubleshooting System
Memory" on page 173.