Programming Stay Mode 2 Zones; Disarming The System; User Codes; Adding User/Radio Codes - Bosch ICP-SOL2-P User Manual

Control Panel
5.1.5

Programming STAY Mode 2 Zones

Programming zones to be automatically isolated in STAY Mode 2 are only carried out if you
have a Master Code or Installer Code.
How to Program STAY Mode 2 Zones
1.
2.
3.
5.2

Disarming the System

When you enter the premises after the system is armed in AWAY mode, or if you armed the
system in STAY Mode 1 or STAY Mode 2, you must disarm the system to disable detection
devices that activate an alarm.
If there was an alarm condition prior to disarming the system, a flashing zone indicator
displays, indicating a previous alarm on that zone.
How to Disarm the System
Enter your user code followed by the [#] button (for example, [2580#]). Two beeps sound.
5.3

User Codes

5.3.1

Adding User/Radio Codes

Only the Master Code holder can add or change other system user codes, including the Master
Code. Up to 32 user codes / radio user codes can be programmed to operate the system.
How to Add a User Code
1.
2.
3.
To add or change other User Codes, repeat this procedure as many times as required.
5.3.2

Deleting User/Radio Codes

Only the Master Code holder can delete other system user codes.
How to Delete a User Code
1.
2.
Bosch Security Systems, Inc.
Enter your Master Code or Installer Code, followed by [4] and the [#] button (for
example, followed [25804#]). Three beeps sound and the STAY indicator flashes.
Enter the zone number to be automatically isolated, followed by the [*] button (for
example, [1*] = Zone 1, [2*] = Zone 2). The selected zone flashes. If you make a mistake,
enter the same zone number followed by the [#] button to clear the incorrect zone. To
select additional zones to be automatically isolated in STAY Mode 2, repeat Step 2 as
many times as required.
Press the [#] button to exit this mode when you finish selecting all zones to be
automatically isolated in STAY Mode 2. Two beeps sound and the STAY and AWAY
indicators turn off.
Enter your Master Code, followed by [1] and the [#] button (for example, [25801#]).
Three beeps are heard and the STAY and AWAY indicators flash.
Enter the User Code number (1 to 32), followed by the [#] button (for example, [2#] =
User 2, [8#] = User 8). Two beeps are heard and the selected user number displays on
the codepad indicators.
Enter the digits required for the new code followed by the [#] button (for example, for
User Code 5768, enter [5768#]). Two beeps are heard and the STAY and AWAY indicators
turn off.
Enter your Master Code, followed by [1] and the [#] button (for example, [25801#]).
Three beeps sound and the STAY and AWAY indicators flash.
Enter the user code number (1 to 32), followed by the [#] button (for example, [2#] =
User 2, [16#] = User 16). Two beeps sound and the selected user number displays on the
codepad indicators.
Operation with ICON LCD Codepad | en
User's Guide
17
2014.05 | 01 | F01U298028