Ieee1394 Connection - JVC GY-HM790CHU Instructions Manual

[PHONES] Terminal
Audio output from the [PHONES] terminal can be selected
using [Audio Monitor] in the [A/V Out] menu (A Page 93) as
well as the [MONITOR SELECT] switch on the camera
recorder.
The different combinations of settings that are output from
the [PHONES] terminal and monitor speaker are as follows.
[MONITOR
SELECT] [Audio Monitor]
Switch Settings
Settings
[CH-1]
[BOTH]
[CH-2]
Downloaded From VideoCamera-Manual.com Manuals
[PHONES]
Terminal
L R
^ CH1
[Mix] CH1+CH2
[Stereo] CH1 CH2
^ CH2

IEEE1394 Connection

" Backup recording " can be performed, which allows the
same image recorded to the SDHC card on the camera
recorder to be recorded to the external device connected to
the IEEE1394 terminal. (A Page 124)
Speaker
CH1
CH1+CH2
CH2
Note :
● When connecting the camera recorder to an external
device using an IEEE1394 cable, make sure to observe
the following. Improper connection may cause the circuit
of the connected unit to malfunction.
● Turn off the power of the camera recorder and
connected devices before connecting the IEEE1394
cable.
● Do not connect the cable in an environment where
static electricity occurs or is likely to occur.
● Make sure that each camera recorder is connected to
only one external device at any one time.
● When the video format input from the [IEEE1394] terminal
is different from the video format of the camera recorder, a
AVIDEO FORMAT INCORRECTB message is
displayed. Set according to the video format entered for
[System Definition], [Camera Resolution], and
[Frame & Bit Rate] in the [Record Format] menu.
(A Page 75)
● If the [INT/EXT] IEEE1394 interface terminal switch is set
at AEXTB and the AHQB mode is selected in
[Frame & Bit Rate], signals will not be output from the
[IEEE1394] terminal. (A Page 75)
[IEEE1394] Terminal
VIDEO FORMAT
INCORRECT
123