Ieee1394 Connection - JVC HM700U - Camcorder - 1080p Instruction Manual

[PHONES] Terminal
Audio output from the [PHONES] terminal can be selected
using [Audio Monitor] in the [A/V Out] menu (A Page 87) as
well as the [MONITOR SELECT] switch on the camera
recorder.
The different combinations of settings that are output from
the [PHONES] terminal and monitor speaker are as follows.
[MONITOR SELECT] [Audio Monitor]
Switch Settings
[CH-1]
[BOTH]
[CH-2]

IEEE1394 Connection

Connecting an external device to the IEEE1394 terminal
enables you to perform the following.
A
Backup recording (A Page 113)
The images recorded on the SDHC card in the camera
recorder can be backed up.
B
Stream transmission to a non-linear editing system
(A Page 114)
Playback images on the camera recorder can be stream
output during editing using a non-linear editing system.
[HD/DV] IEEE 1394
Terminal Mode
Switch
[PHONES] Terminal
Settings
L
^
CH1
[Mix] CH1+CH2
[Stereo] CH1
^
CH2
[IEEE1394] Terminal
Note :
● When connecting the camera recorder to an external device
using an IEEE1394 cable, make sure to observe the
following. Improper connection may cause the circuit of the
connected unit to malfunction.
● Turn off the power of the camera recorder and
connected devices before connecting the IEEE1394
cable.
● Do not connect the cable in an environment where
R
static electricity occurs or is likely to occur.
● Make sure that each camera recorder is connected to
only one external device at any one time.
● Turn off the power of the camera recorder and
CH2
connected devices before switching the [HD/DV]
IEEE1394 terminal mode switch.
● A message indicating VIDEO FORMAT INCORRECT
appears if the format of the input/output video signals from
the [IEEE1394] input terminal is different from the [HD/DV]
IEEE1394 terminal mode switch setting. Adjust the [HD/DV]
IEEE394 terminal mode switch according to the video
format.
VIDEO FORMAT
INCORRECT