Network Settings - NEC EXPRESSSCOPE Engine 3 User Manual

NETWORK SETTINGS

This section describes how to confirm and modify the network setting for management LAN
through the command line interface. To move the current default target to
/admin1/sp1/enetport1, enter the following command at the command prompt:
cd /admin1/sp1/enetport1
Enter the following command, if you would like to confirm properties of the Ethernet port
target which is /admin1/sp1/enetport1.
show
The properties which the Ethernet port target contains are as follows:
• PermanentAddress
This specifies the MAC address for the management LAN. This property is read-only.
• AutoSense
This indicates whether Auto Negotiation is enabled for the LAN Connection Type
setting of the management LAN. Note that, the valid values for this property are
"TRUE" and "FALSE". "TRUE" means that the Auto Negotiation is enabled. "FALSE"
means that the Auto Negotiation is disabled. This property is read-only.
• FullDuplex
This indicates whether Full Duplex Mode is enabled for the LAN Connection Type
setting of the management LAN when the Auto Negotiation (AutoSense) is disabled
(FALSE). The value of this property is not displayed when the Auto Negotiation
(AutoSense) is enabled (TRUE). This property is read-only.
• PortType
This indicates Link Speed ("10Base-T" or "100Base-TX") for the LAN Connection Type
setting of the management LAN when the Auto Negotiation (AutoSense) is disabled
(FALSE). The value of this property is not displayed when the Auto Negotiation
(AutoSense) is enabled (TRUE). This property is read-only.
Followings describe how to confirm and modify the access limitation setting for management
LAN through the command line interface. To move the current default target to
/admin1/sp1/enetport1/lanendpt1, enter the following command at the command prompt:
cd /admin1/sp1/enetport1/lanendpt1
Enter the following command, if you would like to confirm properties of the access limitation
target which is /admin1/sp1/enetport1/lanendpt1.
show
Enter the following command if you would like to modify a property of the access limitation
target.
set <Property>=<New value>
- -
47