Remote Console - NEC EXPRESSSCOPE Engine 3 User Manual

Remote Console

To start a character-based remote console, enter the following command at the command
prompt.
start /admin1/system1/textredirectsvc1
To return from the character-based remote console to the command interface session, enter
the <ESC>stop keys (<ESC>key, <s>key, <t>key, <o>key and <p>key) during the
character-based remote console.
The standard serial port B (COM B) on the host system cannot be
used for connecting another device in this cases because the BMC
Notice
occupies the serial port B.
To use a character-based remote console, set appropriate settings for
the console redirection function of the host system's serial port on
the BIOS Setup Utility in advance.
Especially, please use the following items by the following setting:
• BIOS Redirection Port :
• Baud Rate :
• Flow Control:
• Terminal Type:
For the system BIOS Setup Utility, please refer to the User's Guide of
your host system.
Only a single user among users who are using the command line
interface or ESMPRO/ServerManager (a software application bundled
for remote management) can use a character-based remote console
via the command line interface or ESMPRO/ServerManager. Once the
first user uses the character-based remote console, other users
cannot use any character-based remote console from any SSH clients
or ESMPRO/ServerManager. Check whether another user is using a
character-based remote console, if you cannot use a character-based
remote console.
To show the usage status of the character-based remote console by other users of the
command line interface or ESMPRO/ServerManager, enter the following command at the
command prompt.
show /admin1/system1/textredirectsvc1/textredirectsap1
You can confirm the usage state by value of EnabledState of the "Properties" which is
displayed by the command.
EnabledState=2 : Using the character-based remote console by current user or other
user.
EnabledState=6 : Not in use.
Serial Port B
19.2K
CTS/RTS
PC ANSI
- -
36