NEC EXPRESSSCOPE Engine 3 User Manual page 51

set <Property>=<New value>
The properties which the HTTP service target contains are as follows:
• EnabledState
This specifies whether HTTP port is enabled for the management LAN. The valid
values for this property are "2" and "3". "2" means that the HTTP port is enabled. "3"
means that the HTTP port is disabled. This is the dynamic setting.
• oemnec_httpport
This specifies the HTTP port for the management LAN. This is the dynamic setting.
Followings describe how to confirm and modify the HTTPS service for management LAN
through the command line interface. To move the current default target to
/admin1/sp1/httpssvc1, enter the following command at the command prompt:
cd /admin1/sp1/httpssvc1
Enter the following command, if you would like to confirm properties of the HTTPS service
target which is /admin1/sp1/httpssvc1.
show
Enter the following command if you would like to modify a property of the HTTPS service
target.
set <Property>=<New value>
The properties which the HTTPS service target contains are as follows:
• EnabledState
This specifies whether HTTPS port is enabled for the management LAN. The valid
values for this property are "2" and "3". "2" means that the HTTPS port is enabled. "3"
means that the HTTPS port is disabled. This is the dynamic setting.
• oemnec_httpsport
This specifies the HTTPS port for the management LAN. This is the dynamic setting.
Followings describe how to confirm and modify the SSH service for management LAN
through the command line interface. To move the current default target to
/admin1/sp1/sshsvc1, enter the following command at the command prompt:
cd /admin1/sp1/sshsvc1
Enter the following command, if you would like to confirm properties of the SSH service
target which is /admin1/sp1/sshsvc1.
show
- -
51