NEC EXPRESSSCOPE Engine 3 User Manual page 52

Enter the following command if you would like to modify a property of the SSH service target.
set <Property>=<New value>
The properties which the SSH service target contains are as follows:
• EnabledState
This specifies whether SSH port is enabled for the management LAN. The valid
values for this property are "2" and "3". "2" means that the SSH port is enabled. "3"
means that the SSH port is disabled. This is the dynamic setting.
• oemnec_sshport
This specifies the SSH port for the management LAN. This is the dynamic setting.
- -
52