Confirming System Information - NEC EXPRESSSCOPE Engine 3 User Manual

CONFIRMING SYSTEM INFORMATION

This section describes how to confirm the system information (product, BIOS/BMC firmware
revision, MAC address of System LAN, CPU, Memory) through the command line interface.
The values of the properties for items not supported by the host
system is not displayed for the system information. Moreover, the
values of the properties for items supported with the host system
might not be displayed the system information according to a state of
a power supply and mounting such as a device of the system either.
Confirming Product Information
You can confirm the product information through the command line interface by entering
following the basic command at the command prompt.
show /admin1/system1
In this case, value of oemnec_productname property indicates "Product Name" information at
the "Properties" section. Also value of oemnec_modelnumber property indicates "Part /
Model Number" information and value of oemnec_serialnumber property indicates "Product
Serial Number" information. These properties for the product information are read-only.
Confirming MAC address of System LAN
To move the current default target to /admin1/system1, enter the following command at the
command prompt.
cd /admin1/system1
Here, to confirm all the targets for System LAN (onboard LAN), enter the following command
at the command prompt. All the System LAN targets are represented as enetport<N> strings
at "Targets" section. <N> means value of one-origin integer.
show
Next, when the following command is input, the MAC address of the System LAN target is
appeared at the right side of "PermanentAddress=" string. <N> means the number of the
System LAN target which you would like to confirm.
show enetport<N>
For example, enter the following command when you would like to confirm the MAC address
of LAN Port1.
show enetport1
- -
56