NEC EXPRESSSCOPE Engine 3 User Manual page 50

• AccessInfo
This specifies the IP address of the default gateway for the management LAN. This
property is read-only.
Followings describe how to confirm and modify the network setting with disabling DHCP for
management LAN through the command line interface. To move the current default target to
/admin1/sp1/enetport1/lanendpt1/ipendpt1/staticipsettings1, enter the following command at
the command prompt:
cd /admin1/sp1/enetport1/lanendpt1/ipendpt1/staticipsettings1
Enter the following command, if you would like to confirm properties of the static network
setting target which is /admin1/sp1/enetport1/lanendpt1/ipendpt1/staticipsettings1.
show
Enter the following command if you would like to modify a property of the static network
setting target.
set <Property>=<New value>
The properties which the static network setting target contains are as follows:
• IPv4Address
This specifies the IP address for the management LAN when DHCP is disabled. This
is the dynamic setting.
• SubnetMask
This specifies the subnet mask for the management LAN when DHCP is disabled.
This is the dynamic setting.
• GatewayIPv4Address
This specifies the IP address of the default gateway for the management LAN when
DHCP is disabled. This is the dynamic setting
Followings describe how to confirm and modify the HTTP service for management LAN
through the command line interface. To move the current default target to
/admin1/sp1/httpsvc1, enter the following command at the command prompt:
cd /admin1/sp1/httpsvc1
Enter the following command, if you would like to confirm properties of the HTTP service
target which is /admin1/sp1/httpsvc1.
show
Enter the following command if you would like to modify a property of the HTTP service
target.
- -
50