Power Consumption Control - NEC EXPRESSSCOPE Engine 3 User Manual

POWER CONSUMPTION CONTROL

You can control the power consumption of the host system through the command line
interface.
The user must have an account as administrator for controlling the
power consumption.
To move the current default target to /admin1/system1, enter the following command at the
command prompt:
cd /admin1/system1
State confirmation and modification of Power Consumption Control
Enter the following command, if you would like to confirm properties related to the power
consumption.
show
Enter the following command if you would like to modify a property related to the power
consumption.
set <Property>=<New value>
The properties related to power consumption on /admin1/system1 are as follows. The "()" of
the property name is a property name in the specific product.
"oemnec_ProcessorCoreDisableMax", "oemnec_ProcessorCoreDisable",
"oemnec_BootPerfomanceOptimized", "oemnec_BootTimeConfig",
"oemnec_NonAggressiveModeCorrectionTimeLimit",
"oemnec_NonAggressiveModeCapvalue", "oemnec_NonAggressiveModeSetableCapvalue",
"oemnec_NonAggressiveMode" don't display at specific product:
• EnabledState
The value is always "2".This specifies whether SSH port is enabled for the
management LAN. This property is read-only.
• oemnec_SafePowerCapping
This specifies whether fault check of the power consumption sensor is enabled. The
valid values for this property are "enabled" and "disabled". "enabled" means that the
fault check is enabled. "disable" means that the fault check is disabled. Default setting
is "disabled".
• oemnec_ProcessorCoreDisableMax
This specifies Max Core number which can be set from
oemnec_ProcessorCoreDisable property. This property is not displayed if
oemnec_BootTimeConfig is disabled.
• oemnec_ProcessorCoreDisable
This specifies the number of CPU core to disable. This is the dynamic setting. This
property is not displayed if oemnec_BootTimeConfig is disabled.
- -
53