Working Speed Governor - Mercedes-Benz Sprinter Operating Instructions Manual

Working mode
172
The camera is in the middle of the roof above
the high-mounted brake lamp (
The rear view camera may show obstacles in
perspectival distortion, incorrectly or not at
all. The rear view camera cannot display all
objects located very near and/or under the
rear bumper. It does not warn you of a colli-
sion, persons or objects.
The area behind the vehicle is displayed in a
mirrored fashion, as in the rear-view mirror or
the exterior mirrors.
The function of the rear view camera may be
partially or completely impaired in the follow-
ing circumstances:
it is raining very heavily or snowing, or it is
R
foggy.
the parking space is located in a very dark
R
place.
the camera is exposed to very strong white
R
light. White stripes may appear on the dis-
play.
the surrounding area is illuminated with flu-
R
orescent light. The display may flicker.
if the temperature changes very quickly, for
R
example if you drive into a heated garage in
the winter.
ambient temperatures are very high.
R
the camera lens is dirty or obstructed.
R
the rear of the vehicle is damaged. In this
R
case, have the position and setting
checked at a specialist workshop.
The rear view camera is activated when you
engage reverse gear R.
You can find information on cleaning the cam-
era in the "Maintenance and care" section
( page 269).
Y
Working mode
page 269).
Y
ADR (working speed governor)
General notes
When activated, ADR automatically increases
the engine speed to a preset speed or a speed
you have set.
After a cold start, the idling speed of the
i
engine is increased automatically. If the
preset working speed is lower than the
increased idling speed, the working speed
is only reached once the engine has com-
pleted the warm-up phase.
It is only possible to activate ADR with the
vehicle stationary and the parking brake
applied.
The selector lever of the automatic trans-
mission must be in position P.
Activating/deactivating ADR
To activate: press upper section : of the
X
E switch while the engine is running.
The indicator lamp in the switch comes on.
The K indicator lamp in the instrument
cluster lights up or the display shows the
following message:
governor
To deactivate: press lower section ; of
X
the E switch while the engine is run-
ning.
The indicator lamp in the switch goes out.
Operating speed
active.