Mercedes-Benz Sprinter Operating Instructions Manual page 271

Clean all sensors : in the front and rear
X
bumpers with water, shampoo and a soft
cloth.
Cleaning the rear view camera
! Do not use dry, coarse or hard cloths and
do not scrub. Otherwise, you will scratch or
damage the lens of the rear-view camera.
If you clean the vehicle with a high-pressure
or steam cleaner, maintain a distance of at
least 1.650 cm from the rear-view camera.
Do not aim directly at the rear-view camera
or at the microphone opening on the under-
side of the rear-view camera. You could
otherwise damage the rear-view camera.
Rear view camera in the middle of the roof above
the high-mounted brake lamp
Camera lens
:
Microphone openings
;
Clean camera lens : with clean water and
X
a soft cloth.
Make sure that you do not apply any wax to
camera lens : when waxing the vehicle. If
necessary, remove the wax using water,
shampoo and a soft cloth.
Cleaning the sliding door
Remove foreign objects from the vicinity of
X
the contact surfaces and contact pins of
the sliding door.
Clean the contact surfaces and contact
X
pins with a mild cleaning agent and a soft
cloth.
Do not oil or grease the contact plates and
contact pins.
Steps
Cleaning the electrical step
Clean the electrical step at least once a
month. Make sure that no dirt accumulates in
the housing or on the step.
Extend the electrical step (
X
Close the sliding door until the door lock
X
engages.
The electrical step remains extended for
cleaning.
Clean the electrical step and the housing
X
with a power washer.
After cleaning, spray the step guides on
X
each side with silicone spray when the
housing and electrical step are dry.
Do not use oil or grease as a lubricant.
Retract the electrical step.
X
Access step in the bumper
Example: access step in the bumper
Pay attention to the important safety notes in
the "Notes on care" ( page 265) and "Power
Y
washers" ( page 266) sections.
Y
Keep step in the bumper : free from dirt,
such as:
mud
R
clay
R
snow
R
ice
R
Care
269
page 73).
Y
Z