Mercedes-Benz Sprinter Operating Instructions Manual page 89

To raise: pull the head restraint up to the
X
desired position.
To lower: press release button : and slide
X
the head restraint down to the desired posi-
tion.
To adjust the angle: hold the front part of
X
the luxury head restraint by the lower edge
and tilt it to the desired position.
To remove: pull the head restraint up to
X
the stop.
Press release button : and pull out the
X
head restraint.
To insert: insert the head restraint so that
X
the rod with the detents is on the left when
viewed in the direction of travel.
Press and hold release button :.
X
Push the head restraint down until it
X
engages.
Armrests
To set the armrest angle: fold the armrest
X
upwards by more than 45° ;.
The armrest is released.
Fold armrest = forwards to the stop.
X
Slowly fold the armrest upwards to the
X
desired position.
To fold the armrest up: if necessary, fold
X
the armrest upwards : by more than 90°.
Seat heating
G
WARNING
Repeatedly switching on the seat heating can
cause the seat cushion and backrest pads to
become very hot. The health of persons with
limited temperature sensitivity or a limited
ability to react to excessively high tempera-
tures may be affected or they may even suffer
burn-like injuries. There is a risk of injury.
Therefore, do not switch the seat heating on
repeatedly.
! When you leave your seat, do not place
anything on the seat and switch off the seat
heating. Do not switch the seat heating on
when the seat is not occupied, e.g. when
driving without a co-driver. The seat heat-
ing may otherwise overheat, causing dam-
age to the seat.
The three red indicator lamps in the c
button show the activated heating level 1 to
3.
The system automatically switches down
from level 3 to level 2 after approximately
five minutes.
The system automatically switches down
from level 2 to level 1 after approximately
ten minutes.
At level 1, the seat heating remains in con-
tinuous operation.
Seats
87
Z