Working Mode; Adr (Working Speed Governor) - Mercedes-Benz Sprinter Operator's Manual

Working mode

172
The rear view camera is a visual parking aid.
Information on operation can be found in the
separate Audio 15 supplement.
The camera is in the middle of the roof above
the high-mounted brake lamp (
The rear view camera may show obstacles in
perspectival distortion, incorrectly or not at
all. The rear view camera cannot display all
objects located very near and/or under the
rear bumper. It does not warn you of a colli-
sion, persons or objects.
The area behind the vehicle is displayed in a
mirrored fashion, as in the rear-view mirror or
the exterior mirrors. The guide lines displayed
assist you in backing up.
The function of the rear view camera may be
partially or completely impaired in the follow-
ing circumstances:
it is raining very heavily or snowing, or it is
R
foggy.
the parking space is located in a very dark
R
place.
the camera is exposed to very strong white
R
light. White stripes may appear on the dis-
play.
the surrounding area is illuminated with flu-
R
orescent light. The display may flicker.
if the temperature changes very quickly, for
R
example if you drive into a heated garage
in the winter.
ambient temperatures are very high.
R
the camera lens is dirty or obstructed.
R
the rear of the vehicle is damaged. In this
R
case, have the position and setting
checked at a specialist workshop.
The rear view camera is switched on when
you engage reverse gear R.
You can find information on cleaning the cam-
era in the "Maintenance and care" section
( page 271).
Y
Working mode

ADR (working speed governor)

General notes
page 271).
Y
When activated, ADR automatically increases
the engine speed to a preset speed or a speed
you have set.
i
After a cold start, the idling speed of the
engine is increased automatically. If the
preset working speed is lower than the
increased idling speed, the working speed
is only reached once the engine has com-
pleted the warm-up phase.
It is only possible to activate ADR with the
vehicle stationary and the parking brake
applied.
The selector lever of the automatic trans-
mission must be in position P.
Activating/deactivating ADR
To activate: press upper section : of the
X
E switch while the engine is running.
The indicator lamp in the switch comes on.
The K indicator lamp in the instrument
cluster lights up or the display shows the
following message:
governor governor active
To deactivate: press lower section ; of
X
the E switch while the engine is run-
ning.
The indicator lamp in the switch goes out.
Operating speed Operating speed
active.