Mercedes-Benz Sprinter Operating Instructions Manual page 184

On-board computer (vehicles without steering wheel buttons)
182
Fuel filler flap location indicator t: the
=
fuel filler flap is on the left-hand side. Fuel
filler flap location indicator u: the fuel
filler flap is on the right-hand side
Reserve fuel warning lamp (
?
DEF gauge
Vehicles without steering wheel but-
tons
If the supply of DEF is less than 1.5 US gal
(5.5 l), the å indicator lamp lights up and
dEF Chk
the ¯
If the supply of DEF falls below the reserve
range of 0.8 US gal (3.0 l), the å indicator
lamp lights up and the ¯
display message appears. In the display,
corresponds to the number of possible
remaining engine starts
When the number of remaining engine starts
0
is the engine management prevents the
vehicle being driven at a speed exceeding
5 mph (8 km/h). The multifunction display
StArtS IdLE
shows the
hear a warning tone sequence.
Further information on DEF consumption can
be found in the "Service products and filling
capacity" section (
Vehicles with steering wheel buttons
If the supply of DEF is less than 1.5 US gal
Check Diesel Exhaust Fluid
(5.5 l), the
See Operator's Manual
in the display.
If the DEF supply falls below the reserve range
of 0.8 US gal (3.0 l), the å
remaining
message is displayed. In the dis-
XX
play, corresponds to the number of possi-
ble remaining engine starts
When the number of remaining engine starts
0
is the engine management prevents the
vehicle from being driven at a speed exceed-
ing 5 mph (8 km/h). The multifunction display
Idle Mode
shows the
a warning tone sequence.
page 224)
Y
display message appears.
StArtS RExx
xx
0
(16 to ).
message and you
page 320).
Y
message is shown
XX starts
0
(16 to ).
message and you hear
Further information on DEF consumption can
be found in the "Service products and filling
capacity" section ( page 320).
Y
On-board computer (vehicles without
steering wheel buttons)
Operating the on-board computer
General notes
The on-board computer is activated as soon
as you turn the key to position 1 in the ignition
lock.
The on-board computer shows vehicle infor-
mation and settings in the display.
You can control the display and the settings in
the on-board computer using the adjustment
buttons on the instrument cluster.
Standard display
Odometer
:
Trip odometer
;
Clock
=
Outside temperature or digital speedom-
?
eter
Fuel gage ( page 181)
Y
A
Selector lever position or current shift
B
range with automatic transmission
( page 142)
Y
To call up the standard display: turn the
X
key to position 2 in the ignition lock.
Press the 4 menu button for longer than
X
1 second.
The information shown in the display
changes from the outside temperature to
the digital speedometer.