Mercedes-Benz Sprinter Operating Instructions Manual page 185

On-board computer (vehicles without steering wheel buttons)
Menus in the on-board computer
Overview
If you wish to exit a menu and go to the stand-
ard display:
Press the 4 menu button for longer than
X
1 second.
or
Do not press any button for 10 seconds.
X
The display accepts the changed settings.
Using the f, g, 4 or 9 adjustment but-
tons, you can select the following functions:
Calling up the service due date
R
( page 258)
Y
Checking the oil level (
R
Checking the DEF supply (
R
Preselecting/setting the auxiliary heating
R
switch-on time ( page 124)
Y
Tire pressure monitor (
R
Setting the time ( page 183)
Y
R
Activating/deactivating Highbeam Assist
R
( page 192)
Y
Setting the daytime running lamps
R
( page 92)
Y
Setting the time
Turn the key to position 2 in the ignition
X
lock.
Press the 4 menu button repeatedly until
X
the hours figure flashes.
Press the f or g button to set the hour.
X
Press the 9 reset button.
X
The minute display flashes.
Press the f or g button to set the minute.
X
If you keep the f or g button pressed,
i
the value will change continuously.
Activating/deactivating Highbeam
Assist
X
X
X
Switching the daytime running lamps
on/off
If you switch the daytime running lamps on,
the daytime running lamps will automatically
light up when the engine is running.
page 250)
Y
For safety reasons, it is only possible to
page 182)
Y
change this setting when the vehicle is sta-
tionary. The factory setting is
in which daytime running lamp mode or day-
page 291)
Y
time running lamps are mandatory.
X
X
X
i
Turn the key to position 2 in the ignition
lock.
Press the 4 menu button repeatedly until
the _ indicator lamp flashes and the
OFF
or message appears in the display.
Use the f or g button to switch High-
beam Assist on/off.
Turn the key to position 2 in the ignition
lock.
Press the 4 menu button repeatedly until
the L indicator lamp flashes and the
OFF
or message appears in the display.
Press the f or g button to activate or
deactivate the daytime running lamps.
USA only:
If you turn the light switch to T or L,
the corresponding light switches on. If you
turn the light switch to Ã, the daytime
running lamps remain switched on.
Canada only:
If you turn the light switch to L, the low-
beam headlamps switch on. If you turn the
light switch to T or Ã, the daytime
running lamps remain switched on.
183
on
on
in countries
on
Z