Ubiquiti UniFi UAP User Manual page 7

UniFi AP/AP-LR User Guide
6. Align the notches on the AP with the notches on the
wall-mount bracket.
7. Turn the AP clockwise until it locks into place.
Ceiling-Mount
1. Remove the ceiling tile.
2. Align the ceiling-mount plate to the center of the top
side of the ceiling tile.
3. Use a 3.5 mm drill bit to drill holes for the three flat
head screws.
4. Cut or drill a circle approximately 25 mm in size that
lines up with the larger circle on the ceiling-mount
plate. This will be used for the Ethernet cabling.
Ubiquiti Networks, Inc.
5. Secure the wall-mount bracket and ceiling-mount plate
to the ceiling tile using the 3 flathead screws and 3 nuts
with tooth washers.
6. Feed the Ethernet cable through the hole and then
align the UniFi AP with the notches on the wall-mount
bracket.
Note: The UniFi AP supports Passive PoE which
works with the included PoE adapter. If you
want to power the UniFi AP from an 802.3af
compliant switch, Ubiquiti Networks offers the
optional Instant 802.3af Adapter to instantly
transform any PoE device into a fully 48V
802.3af compliant product.
Product details are available on our website at
http://ubnt.com/8023af
7. Turn the AP clockwise until it locks into place.
Chapter 2: Installation
4